ESD Precautions | Acer M11E instruction

1.4ESD Precautions

Always observe the following ESD (electrostatic discharge) precautions before installing any system component:

1.Do not remove any system component from its packaging unless you are ready to install it.

2.Wear a wrist grounding strap before handling electronic components. Wrist grounding straps are available at most electronic component stores.

DO NOT attempt the procedures in the following sections unless you are confident of your capability to perform them. Otherwise, ask a service technician for assistance.

1-10	User’s Guide

Image 26

Acer M11E manual ESD Precautions

Contents

M11E System Copyright Important Safety Instructions Page Page CD ROM Safety Warning Vii FCC Class B Radio Frequency Interference Statement About this Manual Purpose Manual Structure Conventions Table of Contents Bios Utility Xii Xiii List of Figures Xiv List of Tables Page Features System Board User’s Guide Major Components System Board Layout with Network Connector System Board Layout System Board Layout without Network Connector Jumpers and Connectors Jumper and Connector Locations Blackened pin of a jumper or connector represents pin Jumper Settings Connector Functions JP1 ESD Precautions Installing the Pentium II processor Attaching the Processor Fan Sink Removing tape protector from Fan SInk Locking a Wide Clip End 10 Locking the metal bracket Installing a Pentium II Processor 11 Installing the Pentium II Retention Mechanism 12 Installing the Pentium II Retention Mechanism 13 Installing a Pentium II Processor Removing a Pentium II Processor 14 Securing the Pentium II Processor 16 Removing the Pentium II Processor Memory Upgrade Memory Configurations Installing a Dimm 17 Installing a Dimm Removing a Dimm 18 Removing a Dimm Reconfiguring the System Installing Expansion Cards Installing PCI Cards Installing ISA Cards Bios detects and configures only PnP cards Installing an AGP Card 20 Installing an ISA Card 21 Installing an AGP Card System Error Messages Error MessagesSoftware Error Messages System Board Mmmmssssooo Wxxxx Correcting Error Conditions Page Setup Utility Entering Setup Setup Utility Setup Utility System Information Internal Cache Size ProcessorProcessor Speed Floppy Drive B External CacheFloppy Drive a IDE Primary Channel Master Serial Port IDE Secondary Channel SlaveTotal Memory Parallel Port 15 PS/2 Mouse System S/N Product InformationProduct Name Main Board ID Main Board S/N System Bios VersionDMI Bios Version Disk Drives Floppy Drives IDE Primary Channel Master 2 LS-120 Drive Compatible AsIDE Drives IDE Secondary Channel Slave IDE Primary Channel SlaveIDE Secondary Channel Master This parameter specifies the size of your hard disk, in MB Disabled Enhanced IDE Features DMA Transfer Mode Base Address Onboard PeripheralsSerial Ports 1 ∙ 3BCh ∙ 378h ∙ 278h Onboard Device Settings Operation Mode PS/2 Mouse Controller Floppy Disk ControllerIDE Controller USB Host Controller SMBus Interrupt IRQ9 Onboard Ethernet Chip IDE Hard Disk Standby Timer Power ManagementPower Management Mode Modem Ring Indicator Power Switch 4 secSystem Sleep Timer System Wake-up Event Boot Options Boot Sequence First Hard Disk Drive Fast BootSilent Boot Boot from LANDesk Service Agent Num Lock After BootConfiguration Table Memory Test Date and Time Date Time Advanced Options Memory/Cache Options Memory at 15MB-16MB Reserved for Internal Cache CPU CacheExternal Cache For system board with LAN Memory Parity Mode2 PnP/PCI Options PCI IRQ Setting For system board without LAN PCI IRQ Sharing VGA Palette Snoop Graphics Aperture Size Reset Resource AssignmentsCPU Frequency Plug and Play OS Processor Speed Bus FrequencyCPU Multiple System Security Setup PasswordTo set or change a Password Setup Utility To remove your Setup Password To bypass Setup Password Power-on Password Make sure to set JP3 to 1-2 to enable Power-on password Drive Control Settings Disk Drive Control Load Default Settings Abort Settings Change Exit Setup