Acer Veriton 5600GT/5600V, Veriton 3600GT/3600V manual Delay 4 sec, FAN Control, Pci Pirqa-D #

Parameter	Description	Options
Suspend Mode	If system activity is not detected for the length	Disabled, 1 Min, 2 Min, 4 Min, 8
	of time specified in this field, all devices except	Min, 12 Min, 20 Min, 30 Min, 40
	CPU will be shut off.	Min, 1 Hour
HDD Power Down	If HDD activity is not detected for the length of	Disabled
	time specified in this field, the hard disk drive	1 Min through15 Min
	will be powered down while all other devices
	remain active.
Soft-Off by PWR-BTTN	This is a specification of ACPI and supported	Delay 4 sec.
	by hardware. When Delay 4 sec. is selected,	Instant-Off
	the soft power switch on the front panel can be
	used to control power On, Suspend and Off. If
	the switch is pressed less than 4 sec. during
	power On, the system will go into Suspend
	mode. If the switch is pressed longer than 4
	sec, the system will be turned Off. The other
	setting is Instant-Off, where the soft power
	switch is only used to control On and Off, there
	is no need to press 4 sec, and there is no
	Suspend.
CPU THRM-Throttling	The item allows you to specify the CPU speed	From 12.5% to 87.5% at 12.5%
	(at percentage) to which it will slow down when	increment
	the CPU reaches the predetermined overheat
	temperature.
Wake-Up by PCI PME	These fields specify whether the system will be	Disabled
	awakened from power saving modes when	Enabled
	activity or input signal of the specified
	hardware peripheral or component is detected.
FAN CONTROL	This setting is used to enable/disable the fan	Enabled
	speed control function.	Disabled
Power-On by Ring	When Enabled, any fax/ modem activity wakes	Enabled
	up the system from suspend mode.	Disabled
USB KB Wake-up from S3	This setting allows you to enter “Any Key”	Disabled
	(max. 8 numbers) to wake up the system from	Enabled
	S3 state.
Resume by Alarm	Use this option to set the date and time for your	Disabled
	computer to boot up.	Enabled
	Date (of month) Alarm* - Indicate month when	* Set Resume by Alarm to
		Enabled, then press eto
	system will boot up. Set it to 0 if you want to
	boot everyday.	show the range of Date and Time
	Time (hh:mm:ss) Alarm* - Indicate the hour,	Alarm.
	minute and second when system will boot up.
Primary IDE 0/1	The global timer is the hardware timer that	Disabled
Secondary IDE 0/1	counts down to the power saving modes. If the	Enabled
FDD, COM, LPT Port	monitoring of the listed hardware peripherals or
PCI PIRQ[A-D] #	components is enabled, the activity of the spec-
	ified peripherals or components will awaken the
	system or reload the original count of global
	timer when they are accessed.

NOTE: In ACPI mode: Valid-S5 and S4. In APM mode: Valid- shutdown

Chapter 2 42