Actiontec electronic V.90 ISA user manual Table of Contents

Table of Contents
Proprietary Notice and Disclaimer	2
Introduction	3
Contacting Actiontec Customer Support	3
Before You Begin	4
For Windows 95/98 Installation	4
For Windows NT 4.0 Installation	5
Installing The Modem	6
Hardware Installation	6
Connecting Devices to the Modem	8
Configuring Windows 95	9
Configuring Windows 95 OSR2	11
Configuring Windows 98	14
Configuring Windows NT 4.0	19
Installing Communications Software	24
Troubleshooting	25
Appendix A: Non Plug-N-Play Installations	29
COM Ports and Interrupts	29
Jumper Settings	30
Installing In DOS and Windows 3.1x	32
Hardware and Driver Installation	32
Appendix B: AT Command Set	34
AT Commands	34
AT Commands for Testing and Debugging	58
S-Registers Reference	60
Appendix B: Communications Regulations	71

Proprietary Notice and Disclaimer

Unless otherwise noted, this document and the information herein disclosed are proprietary to Actiontec Electronics, Inc. Any person or entity to whom this document is furnished or who otherwise has possession thereof, by acceptance agrees that it will not be copied or reproduced in whole or in part, nor used in any manner except to meet the purposes for which it was delivered.

The information in this document is subject to change without notice and should not be construed as a commitment by Actiontec. Although Actiontec will make every effort to in- form users of substantive errors, Actiontec disclaims all liability for any loss or damage result- ing from the use of this document or any hardware or software described herein, including without limitation contingent, special or incidental liability.

PC is a trademark of IBM Corporation. Windows 3.1, Windows 95, Windows 98, and Windows NT are trademarks of Microsoft, Inc. K56flex is a trademark of Lucent Technologies, Inc. and Rockwell International.

2