CONFIGURATION WORKSHEETS C
This appendix provides worksheets where you can record your system settings and system sessions configuration information prior to executing the procedures in Chapter 4 through Chapter 8.
The information that you need to configure a modem is listed below. Contact your service provider for this information. Use the worksheets in this appendix to record your configuration information. When you begin configuration of the modem in Chapter 4, the procedures refer you to the proper table so you can use the information you have recorded.
CONFIGURATION INFORMATION1System mode (WAN connection for the sessions between the modem and the service provider): PPP over ATM or Bridge/Router RFC 1483?
2If Bridge/Router:
•Configure as a Bridge only, as a Router only, or as a Bridge and Router.
•If Bridge or Router, choose LLC or
•If Router, choose version of and direction for RIP (RIP1, RIP2, or RIP1 compatible).
•If Bridge, select whether or not to enable Spanning Tree.
3If PPP over ATM and using CHAP, identify CHAP authentication name.
4Session address for Ports 1 through 32 (WAN configuration):
•ATM VPI and ATM VCI (specified for each session)
•when using fixed IP addresses, IP address specified for each session by the service provider
•for PPP system mode, Login Name and Login Password (specified for each session)
Megabit Modem 400F, 500L, 600F and 700F User Manual | 107 |