Selecting Configuration Parameters
SELECTING CONFIGURATION PARAMETERSThere are many configuration options for the modem from which you can select. The following options are recommended for enhanced performance.
•DHCP to allow the modem to dynamically serve IP addresses to devices on the LAN
•NAT to map public IP addresses (proxy IP addresses) acquired from the service provider for the WAN sessions to private IP addresses on the LAN
The following table shows possible configurations, with the recommended configuration first:
DHCP | NAT | How IP Address Acquired |
|
|
|
On | On | Dynamic |
Off | On | Dynamic |
On | On | Fixed |
Off | On | Fixed |
Off | Off | Fixed |
|
|
|
For the Megabit Modem 700F only, you can select either PPP over ATM or RFC 1483 bridge/router encapsulation for all sessions you set up. To have all sessions (up to 32) as PPP over ATM mode of operation, do the following:
1From the system menu, select general.
2Select PPP Over ATM as the Mode of Operation.
3Click Apply, then reset the modem.
52 | Megabit Modem 400F, 500L, 600F, and 700F User Manual |