Assigning LAN Users to PPP Sessions

ASSIGNING LAN USERS TO PPP SESSIONS

Map the IP addresses for the LAN-side users to each PPP over ATM session.

In PPP over ATM mode, you can map up to a maximum of 8 users to the sessions you configure for the 500L. In addition, you can map 64 users to the sessions you configure for the 600F and 700F. For example, you could map two users to 32 configured sessions, 64 users to one configured session, or any combination you choose, up to a maximum of 64 users mapped to all the sessions you configure. You can map multiple users to one session; you cannot, however, map multiple sessions to any user.

Enter the IP address or addresses for each user on the LAN that will be assigned to this session. To access, select User Assignment on the PPP over ATM WAN Configuration page.

Information

Description

 

 

Connection Name

The name of the PPP session.

User’s IP Address

The IP address of the LAN-side user’s machine.

Inbound NAT Default

The default device for inbound traffic. This parameter should be configured when

 

setting up the WAN PPP session. See “Configuring the WAN PPP Sessions” on

 

page 53 for more information.

Add a User Assignment

1From the wan menu, click user assignment to open the WAN User Assignment window.

2Click Add to display the user assignment Entry window.

3Configure the user assignment parameters defined in the table above.

4Click Apply to add the new data to the list. To cancel the process, click Cancel.

60

Megabit Modem 400F, 500L, 600F, and 700F User Manual