ADC H2TU-C-388 INSTALLATION

152-388-100-02, Issue 2 Installation

INSTALLATION

Upon receipt of the equipment, inspect the contents for signs of damage. If the equipment has been damaged in transit, immediately report the extent of damage to the transportation company and to ADC.

Figure 2. Installing the H2TU-C-388 into a Shelf

When installing an H2TU-C in a chassis, be sure to wear an antistatic wrist strap. Avoid touching components on the circuit board.

To comply with the intrabuilding wiring requirements of GR-1089 CORE, Section 4.5.9, the shields of the ABAM-type cables that connect the H2TU-C-388 List 1 DSX-1 output ports to the cross-connect panel must be grounded at both ends.

1Align the H2TU-C-388 List 1 with the enclosure slot guides, then push the unit in until it touches the backplane card-edge connector.

2Press down on the H2TU-C-388 front panel to properly seat it.

H2TU-C-388 List 1 June 6, 2000 7