viii

Front Matter

CAUTION: Users should not attempt to make such connections themselves, but should contact the appropriate electric inspection authority, or electrician, as appropriate.

The Ringer Equivalence Number (REN) assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which is used by the device, to prevent over- loading. The termination on a loop may consist of any combination of devices subject only to the requirement that the total REN of all the devices does not exceed 5. The RInger Equivalence Number of this unit is Not Applicable.

FCC PART 15 INFORMATION

This device has been tested and found to comply with FCC Part 15 “Class A” regulations for digital devices. Operation is subject to the following two conditions: (1) This device may not cause harmful interference and (2) This device must accept any interference that may cause undesired operation.

These FCC limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy, and, if not installed and used in accordance with this User Manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area may cause harmful interference. If this happens, the user would be required to correct the interference at his own expense.

FCC REGULATORY REQUIREMENTSNotice to Users of T1 Service

The following instructions are provided to ensure compliance with the Federal Communications Commission (FCC) Rules, Part 68. FCC Regulartory Number: 1H5USA-32637-DE-N.

1.Before connecting your unit, you must inform the telephone company of the following information:

Port ID

REN/SOC

FIC

USOC

 

 

 

 

 

 

 

 

T1 Line

6.0N

04DU9-BN

RJ48C / Dual Bantam Jacks

 

 

 

 

T1 Line

6.0N

04DU9-DN

RJ48C / Dual Bantam Jacks

 

 

 

 

T1 Line

6.0N

04DU9-1KN

RJ48C / Dual Bantam Jacks

 

 

 

 

T1 Line

6.0N

04DU9-1SN

RJ48C / Dual Bantam Jacks

 

 

 

 

2.If the unit appears to be malfunctioning, it should be disconnected from the telephone lines until you learn if your equipment or the telephone line is the source of the trouble. If your equipment needs repair, it should not be reconnected until it is repaired.

3.Ifthetelephonecompanyfindsthatthisequipmentisexceedingtolerableparameters,thetelephonecompany can temporarily disconnect service, although they will attempt to give you advance notice if possible.

4.Under the FCC Rules, no customer is authorized to repair this equipment. This restriction applies regardless of whether the equipment is in or out of warranty.

ADCP-62-023

Issue 1, September 1998

 

© 1998, ADC Telecommunications, Inc.