Tuner Operations

Chapter 4 - Operations

Follow these steps to use the GFR-700HD’s built-in AM/FM tuner. Before you begin, make sure the AM/ FM antennas are properly connected; see page 14.

Selecting Tuner Mode

To select Tuner mode:

•Press the Tuner button on the remote control. or

•Press the FM/AM button on the front panel.

Selecting the Tuner Band

To switch between the AM/FM bands:

•Press the FM/AM/HD button on the remote control. or

•Press the FM/AM button on the front panel.

Switching between Manual and Preset tuning

Manual tuning is used to tune stations and store pre- sets. Preset Tuning is used to select and scan preset stations. To switch between manual and preset tun- ing:

•Press the Pre/Tune button on the remote control. or

•Press the Tuner/Preset button on the front panel.

Tuning Stations Manually

To manually tune stations:

•Press the Tune +/- buttons on the remote con- trol.

-The AM tuner steps in 10KHz increments.

-The FM tuner steps in .05MHz increments.

Tuning Stations Automatically

To automatically scan for stations:

•Press the Seek button on the remote control. or

•Press the Up/Down buttons on the front panel.

Storing Stations as Presets

The GFR-700HD allows you to store up to 64 presets (32 for each band). To store the selected station as a preset:

1Press the Mem button on the remote control.

2 Assign a preset number.

•Pressing the Mem button automatically as- signs the selected station to the next avail- able preset number.

•To assign the preset to a different number, use the Tune +/- buttons to select the de- sired preset number, and then press the Mem button to save.

Selecting Preset Stations

To select preset stations:

•Press the Tune +/- buttons on the remote control. or

•Press the Up/Down buttons on the front panel.

Scanning Preset Stations

To automatically scan your presets:

1Switch to Preset mode.

2Press the Seek button on the remote control to start scanning presets.

•The GFR-700HD will play each preset station for a few seconds in sequential order.

3Press the Seek button again to stop scanning.

Improving Tuner Reception

To improve tuner reception:

•Press the St/Mono button on the remote control to switch between Stereo and Mono reception. Sometimes a poor quality stereo signal will im- prove when switched to Mono mode.

Tuner