
Technical Specifications
PREAMPLIFIER ANALOG SECTION
| Input Impedance | 47k | |
| Output Impedance  | <600 Ohm | |
| Rated Input | 1.0Vrms | |
| Maximum Input (@ 4Vrms Input Sens.) | 4.1Vrms | |
| Rated Output (100k load) | 2.0Vrms | |
| Minimum Load | 5k | |
| Maximum Output | 8Vrms | |
| Volume & Trim Range (relative to 0dB Trim) | ||
| • Main | ||
| • Main Trim | ||
| • Main Input Sens./Input | 1V/2V/4V | |
| • Room 2 | ||
| • Room 2 Trim | ||
| • Room 2 Gain/Input ... | +0dB to +6dB (2.0dB res) | |
| Channel Separation (at 1kHz) | (>65dB) | |
| Frequency Response | 
 | 
 | 
| • Analog DSP Input | 20Hz to 20kHz  | |
•Analog Ext7.1 Input . 20Hz to 100kHz 
| • Analog DSP Input | 0.007% (20kHz Low Pass) | 
| • Analog Ext7.1 Input ... | 0.006% (80kHz Low Pass) | 
| S/N Ratio (ref. 2.0Vrms  | |
| • Analog - DSP Input | 93dB | 
| • Analog - Ext 7.1 Input | 100dB | 
PREAMPLIFIER DIGITAL SECTION
| Frequency Response | 
 | 
 | 
| • Digital Input | 10Hz to 22kHz  | |
| THD+N (@ Rated Input & Output) | 
 | |
| • Digital Input | 0.009%  | |
| S/N Ratio (ref. 2.0Vrms  | 
 | |
| • Digital Input | 99dB | |
| Bass Management (Front/Center/Surround/Sub) | ||
| •  | Crossover Frequency | |
| • (Small Spkr Setting).... | 12dB/octave (2nd order) | |
| (Adj. 40/60/80/100/120/150Hz) | ||
| •  | 24dB/octave (4th order) | |
| (Adj. 40/60/80/100/120/150Hz) | ||
| • Delay Mgmt (Feet or Meters relative 1ms/ft) | ||
| • Front/Center/Surr/Surr Back/Sub | ........  | |
| • Lip Sync Delay | ||
FM TUNER SECTION
Sensitivity
| • 30dB S/N | 6dBu typ. | 
| S/N Ratio | 
 | 
| • Mono | 65dB typ. | 
| • Stereo | 55dB typ. | 
| Distortion | 
 | 
| • Mono | 0.3% typ. | 
| • Stereo | 0.5% typ. | 
| Stereo Separation | 35dB typ. | 
| Adjacent Channel Selectivity | 50dB typ. | 
| Frequency Response | 50Hz to 15kHz  | 
AMPLIFIER SECTION
| Frequency Response | 10Hz to 50kHz  | |
| THD+N | 0.009% | |
| S/N Ratio | 93dB | |
| Power Output (x # = number of channels driven) | ||
| • EIA/CEA  | 145watt | |
| • EIA/CEA  | 265watt | |
| • RMS (8 Ohm x 5) | 109watt | |
| • RMS (4 Ohm x 5) | 148watt | |
| • RMS (8 Ohm x 2) | 150watt | |
| • RMS (4 Ohm x 2) | 226watt | |
| Damping Factor | 
 | 
 | 
| • RMS (8 Ohm x 1) @ 50Hz 1% THD | 102 | |
| • RMS (4 Ohm x 1) @ 50Hz 1% THD | 51 | |
VIDEO SECTION
| Impedance (Input/Output) | 75 Ohm | 
| Bandwidth | 
 | 
| • Composite &  | 6MHz  | 
| • Component | 200MHz  | 
| Transcoding | 
 | 
| •  | 480i & 576i | 
| Switching | 
 | 
| • HD Component (Auto Bypass) | |
| • HDMI (Switching Video/Audio/ | 
 | 
| DDC/HPD) | 
GENERAL
| Supply Voltage (Switchable) | ..............  | 
| 
 | |
| Power Consumption | 1200watt maximum | 
| Dimensions | 
 | 
| • Width | 17 inches (431.8mm) | 
| • Rack Height | 7 inches (177.8mm) | 
| • Full Height | 7.5 inches (190.5mm) | 
| • Depth of Chassis | 15.5 inches (393.7mm) | 
| • Full Depth | 19 inches (482.6mm) | 
| Unit Weight | 50 lbs. (22.7kg) | 
| Trigger Outputs | 
 | 
| • Main | 50mA @ 12vDC | 
| • Room 2 | 50mA @ 12vDC | 
| IR Inputs | 
 | 
| • Main | 3.5mm T/R | 
| • Room 2 | 3.5mm T/R | 
| RS232 Control | 9600 baud/8 -  | 
| 
 | Flow Control = Hardware | 
Specifications are subject to change without notice.
Chapter 5 - Help
| www.adcom.com | 65 | 
