ADIC SNMS 2.3 manual Configuring StorNext FS Software

SNMS

Step 9 When the installation is complete, return to the Install Main Menu (see Figure 3-1).

To review the screen that displays the component-level status of the StorNext FS software installation (see ), type 3 from the Install Main Menu.

Step 10 Type 4 to quit the installation process and exit the menu.

NOTE	Before configuring the StorNext FS software, reboot your system if you are using
	an IRIX operating system.

Configuring StorNext FS Software

Use the following procedure to configure the StorNext FS software that you have installed on your machine.

Step 1 Open your Web browser.

NOTE	Refer to the StorNext Management Suite Release Notes for information about
	browsers that are supported by StorNext FS.

Step 2 Type the full address of your machine and its port number (http://<machine name>: <port number>) in the Address field and press Enter. Use the name of the machine and port number that you copied when you installed the StorNext FS software.

If you did not remember to copy the name of your machine and its port number, you can still access the StorNext FS software. By default, the software runs on port number 81. However, if this port number is being used by another application, then use the next higher number. For instance, if port number 81 isn’t available, then use port number 82; if port number 82 isn’t available, then use port number 83.

Installing StorNext FS on UNIX 3-5