AEG 88830 manual Turn off the tap, then

		Instructions for use
Problem	Possible Cause	Remedy
The drain pump for the		Turn off the tap, then
washing machine runs
	The Aqua Control anti-flood	remove the plug from the
constantly - even when
	system has been activated.	mains and inform Customer
the appliance is
		Service.
switched off.
Conditioner was not	Softener insert in the com-
washed in, compart-		Clean the detergent drawer
	partment for care agent ist
ment æ for care		and firmly attach the soft-
	not correctly attached or is
agents is filled with		ener insert.
	blocked.
water.
		Pay attention to the maxi-
		mum filling quantity (see
Washing heavily	Probably too mush washing	Program tables). Select the
creased.	put in.	program EASY IRON (SANS
		REPASSAGE) for easy-care
		fabrics.
	Drainage hose bent.	Remove the bend.
	The maximum pump height	Contact your customer serv-
		ice. For pumping heights
	(discharge height 1m from
		over lm he can offer you a
Washing not well spun.	the positioned surface of the
		conversion kit as a special
Residual water still vis-	appliance) is exceeded.
		accessory.
ible in the drum.
		Switch off the unit and pull
Error code (2 appears.
	Solution pump blocked.	out the mains plug. Clean
		the solution pump.
	If a siphon is connected:	Clean the siphon.
	Siphon blocked.
	The door is locked for safety	Wait until DOOR (PORTE) is
	reasons (the DOOR (PORTE)
		illuminated in green.
	display is not illuminated).
The filling door cannot		Cancel the program saving
be opened with the	The program saving function
		function (see "Program Sav-
unit switched on.	is set.
		ing").
	The washing machine is in	Press DOOR (PORTE) button
	the stand-by mode.	again.

35