Protect PV.500-MH Operating Instructions

7.1.4.2 Configuring the Modbus Protocol

To access the X5 data protocol configuration, you must press <4> in the main menu:

Figure 19 Data protocol configuration

Press one of the following keys in the “X5 Data Protocol” menu: <TAB> to configure the Modbus protocol

<CR> to accept the set values. The configuration is finished and the main menu is opened again.

<ESC> to cancel the configuration. This opens the main menu.

Figure 20 Modbus protocol configuration

Press one of the following keys in the “X5 Data Protocol – Mod- bus/JBusV2” menu:

<!> to load the factory setting.

<1> to configure the Modbus slave address.

<2> to configure the delay time between a request from the master and the response from the slave.

<CR> to accept the set values. The configuration is finished and the main menu is opened again.

<ESC> to cancel the configuration. This opens the main menu.

50 of 68

80000043212 BAL

Page 50
Image 50
AEG PV.500-MH manual Configuring the Modbus Protocol, Data protocol configuration