Agilent Technologies E9300 manual Power Meter Configuration Changes, Auto-averaging Settings

Power Meter Configuration Changes

Sensor Dynamic Range

Note

Power Meter Configuration Changes

The Agilent EPM series power meter recognizes when an Agilent E-series E9300 power sensor is connected. The sensor calibration data is automatically read by the power meter. In addition, the HP E-series E9300 power sensors change the auto-averaging settings used by the power meter. These are also automatically configured.

						Maximum					Resolution Setting
	E9300/1/4AE9300/1H E9300/1BSensor Power 1										2	3	4
Range										1	1	1	4
		10 dBm			20 dBm	40 dBm
Upper			2 dBm		12 dBm	32 dBm	1				1	4	16
							1				1	8	32
			-4 dBm		6 dBm	26 dBm
							1				4	16	128	Numberof
	-10 dBm				0 dBm	20 dBm
							1				16	64	128
RangeLower							1				1	1	4	Averages
	-20 dBm			-10 dBm		10 dBm
	-30 dBm			-20 dBm		0 dBm		1			1	2	16
								1			2	16	64
	-40 dBm					-10 dBm
				-30 dBm
								4			16	128	256
	-50 dBm					-20 dBm
				-40 dBm					32		64	256	256

Minimum

Sensor Power

Figure 4 Auto-averaging Settings

These values are valid only for the power meter channel connected to the Agilent E-series E9300 power sensor and only while the sensor is connected. Averaging settings can also be manually configured. Refer to “Achieving Stable Results with TDMA Signals” on page 25 if required.

21