Aiwa XD-SPM823 operating instructions Connections, Connecting to audio equipment

Connections (continued)

Connecting to audio equipment

Audio equipment to be connected	Input jack of the audio	Refer to
to the unit	equipment
None (only a TV is connected)	—	A on pages 15-17
• Amplifier	Digital input jack	B on page 18
• Stereo system
	Analog audio input jacks (L/R)	C on page 19
• Dolby Digital decoder	Digital input jack	D on page 20
• AV receiver equipped with a Dolby Digital or
	Analog audio input jacks (L/R)	F on page 22
Dolby Pro Logic decoder
• DTS decoder	Digital input jack	E on page 21
• AV receiver equipped with a DTS decoder

Notes on digital audio connections

•When using an optical connection, remove the dust cap from the DIGITAL OUT OPTICAL jack on the rear of the unit. Keep the cap handy. When not using the optical connection, the dust cap should be replaced.

•Use either a commercially available optical cord or a 75- ohm coaxial cord when connecting the unit to an AV amplifier with a digital input jack. The supplied video cord can also be used instead of a coaxial cord.

CAUTION

DO NOT select "DOLBY DIGITAL/PCM" or "Stream/PCM" for the "Digital Audio Output" in the setup menu when connecting to an AV receiver not equipped with a Dolby Digital decoder or DTS decoder (with an optical or coaxial connecting cord).

Merely attempting to play a disc may cause a screeching noise which could be harmful to your ears and damage the speakers. In this case, be sure to select "PCM" for the "Digital Audio Output".

Note on DTS-encoded discs

Set "Digital Audio Output" to "Stream/PCM" in the setup menu, after connecting the digital output of this unit to an AV receiver equipped with a DTS decoder.

14 ENGLISH