Aiwa XR-H33MD RADIO RECEPTION cont, Presetting Stations, To change the AM tuning interval

1 Press the TUNER/BAND button repeatedly to select the band.

When the TUNER/BAND button is pressed while the power is off, the power is turned on directly.

2 Press the DOWN or UP button to select a station.

Each time the button is pressed the frequency changes.

When a station is received, "TUNE" is displayed for 2 seconds. During FM stereo reception, is displayed.

To search for a station quickly (Auto Search)

Keep the	DOWN or UP	button pressed until the tuner starts searching for a station. After tuning in to a
station, the search stops.
To stop the Auto Search manually, press the			DOWN or UP	button.
• The Auto Search may not stop at stations with very weak signals.

When an FM stereo broadcast contains noise

Press the MONO TUNER button on the remote repeatedly so that "MONO" lights up on the display. Noise is reduced, although reception is monaural.

To restore stereo reception, press MONO TUNER while pressing SHIFT until "MONO" disappears.

To change the AM tuning interval

The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval as follows.

Press the POWER button while pressing the TUNER/BAND button. To reset the interval, repeat this procedure.

NOTE

When the AM tuning interval is changed, all preset stations are cleared. The preset stations have to be set again.

RADIO RECEPTION (cont.) pg. 8

PRESETTING STATIONS