Aiwa XR-M35 manual Precautions, Electric Power, AC power cord, Outdoor Antenna

WARNING

TO REDUCE THE RISK OF FIRE OR ELECTRIC

SHOCK. DO NOT EXPOSE THIS APPLIANCE TO

RAIN OR MOISTURE.	, ●
A ~		A
RISK OF ELECTRIC SHOCK
	DO NOT OPEN		●

“CAUTION:TO REDUCE THE RISK OF

ELECTRIC SHOCK,

DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.”

Explanation of Graphical Symbols:

The lightning flash with arrowhead symbol, A within an equilateral triangle, is intended to

alert the user to the presence of uninsulated “dangerous voltage” within the product’s en- closure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the

A presence of important operating and mainte- nance (servicing) instructions in the literature

●accompanying the appliance.

PRECAUTIONS

Read the Operating Instructions carefully and completely before operating the unit. Be sure to keep the Operating Instructions for

future reference. All warnings and cautions in the Operating Instructions and on the unit should be strictly followed, as well as the safety suggestions below.

Installation

1Water and moisture – Do not use this unit near water, such as near a bathtub, washbowl, swimming pool, or the like.

2Heat – Do not use this unit near sources of heat, including heating vents, stoves, or other appliances that generate heat. It also should not be placed in temperatures less than 5°C (41 “F)or greater than 35-C(95-F).

3Mounting surface – Place the unit on a flat, even surface.

4Ventilation – The unit should be situated with adequate space around it so that proper heat ventilation is assured. Allow 10 cm (4 in.) clearance from the rear and the top of the unit, and 5 cm (2 in.) from the each side.

-Do not place the unit on a bed, rug, orsimilarsurface that may block the ventilation openings.

-Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded.

5Objects and liquid entry – Take care that objects or liquids do not get inside the unit through the ventilation openings.

6Carts and stands – When placed or mounted on a stand or cart, the unit should be moved with care.

Quick stops, excessive force, and un-		k
even surfaces may cause the unit or	m	A&* 3
cart to overturn or fall.

7 Condensation – Moisture may form on the CD pickup lens when:

-The unit is moved from a cold spot to a warm spot

-The heating system has just been turned on

-The unit is used in a very humid room

-The unit is cooled by an air conditioner

When this unit has condensation inside, it may not function normally. Should this occur, leave the unit for a few hours, then try to operate again.

8Wall or ceiling mounting–The unit should not be mounted on a wall or ceiling, unless specified in the Operating Instructions.

Electric Power

1 Power sources – Connect this unit only to power sources specified in the Operating Instructions, and as marked on the unit.

2Polarization - As a safetv feature, some units are equipped with polarized AC power p(ugs which can only be inserted one

way into a power outlet. If it is difficult orimpossibleto insert the AC power plug into an outlet, turn the plug over and try again. If it still does not easily inserf into the outlet, please call a qualified service technician to service or replace the outlet. To avoid defeating the safety feature of the polarized plug, do not force it into a power outlet.

3AC power cord

-When disconnecting the AC power cord, pull it out by the AC power plug. Do not pull the cord itself.

-Never handle the AC power plug with wet hands, asthiscould result in fire or shock.

-Power cords should be routed to avoid being severely bent, pinched, or walked upon. Pay particular attention to the cord from the unit to the power socket.

-Avoid overloading AC power plugs and extension cords

beyond their capacity, as this could result in fire or shock.

4Extension cored – To help prevent electric shock, do not use a polarized AC power plug with an extension cord, receptacle, or other outlet unless the polarized plug can be completely inserted to prevent exposure of the blades of the plug.

5When not in use – Urmlua the AC power cord from the AC

,0

outlet if the unit will not be used for several months or more. When the cord is plugged in, a small amount of current continues to flow to the unit, even when the power is turned off.

Outdoor Antenna

1 Power lines - When connecting an outdoor antenna, make sure it is located away from power lines.

2Outdoor antenna grounding – Be sure the antenna system is properly grounded-to provide protection against unexpected voltage surges or static electricity build-up. Article 810 of the National Electrical Code, AN S1/NFPA 70, provides information on proper graunding of the mast, supporting structure, and the lead-in wire to the antenna discharge unit, as well as the size of the grounding unit, connection to grounding terminals, and requirements for grounding terminals.

Antenna Grounding According to the National Electrical Code

, ANTENNA LEAD IN WIRE

		/
		ANTENNA		DISCHARGE
		(NEC SECTION			81 0-20)
ELECTRIC		GROUNDING
SERVICE		CONDUCTORS
EQUIPMENT		(NEC SECTION			810-21)
		GROUND	CLAMPS
		POWER SERVICE		GROUNDING
		ELECTRODE	SYSTEM
		(NEC ART 250 PART H)
NEC-NATIONAL	ELECTRICAL	CODE

1 ENGLISH