MANUAL TUNING
BANDI
MODE
1 | TUNER |
| |
| SHIFT |
2
1 Press the TUNER/BAND button repeatedly to select the desired band.
n
If the power is turned off, the previously tuned station will be played (Direct Play Function).
When using the remote control, press the BAND/MODE TUNER button repeatedly while power is on.
2 Press the ++ or ~ button to select a station.
Each time the button is pressed, the frequency changes. When a station is received, TUNE is displayed for a moment. During FM stereo reception, [[[01] is displayed.
To search for a station quickly (Auto Search)
Keep the + or - button pressed until the tuner starts searching for a station. After tuning in to a station, the search stops.
To stop the Auto Search manually, press the+ or - button.
●The Auto Search may not stop at stations with very weak signals.
When an FM stereo broadcast contains noise
Press the BAND/MODE TUNER button while pressing the SHIFT button on the remote control.
“MONO” appears on the display.
Noise is reduced, although reception is monaural.
MONO
To restore stereo reception, repeat the above again.
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If you use this unit in an area where the frequency allocation system is 9 kHz/step, change the tuning interval.
While pressing the TUNER/BAND button, press the POWER button.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see “PRESETTING STATIONS”) are cleared. The preset stations
have to be set again.
7 ENGLISH
