Using the USB Duplicator

Synchronous Copying - continued

4.Finish loading the blank target flash drives, then press the OK button on the display panel.

5.The LCD will display the status of the copying process.
Copy 15%Percent Complete

 

 

Total MBytes

 

 

on source

450M

OK

0:32 68M

ENT

ESC

ESC

Time elapsedMBytes copied
6.When Copy is complete LCD will display the following status:

Total OK: 5

OK: 5

NG: 0

OK

1:03

OK: 5

NG: 0

ENT ESC

ESC

If the Copy fails, the LCD will display the number of flash drives that failed and passed.

Note: When copying is in process the Green LED on the front panel is blinking. Do not take out the drive while it is copying. When copying is finished the Green LED stays on (no blinking). If an error occurs during the copy process a Red LED will display.

Asynchronous Copying

Asynchronous Copy is used only when the source content is the same as or less than the system buffer (256MB). With the source content read into the systems buffer you can copy flash drives continuously by taking out the drive which has finished copying, and replacing it with another blank. This process is repeated until the copying job is complete.

1. Load the source flash drive into the USB Duplicator. Use the UP or DOWN arrow to scroll through the menu until Copy is displayed on the LCD screen.

USB Duplicator 1. Copy

OK

ENT ESC

ESC

www.aleratec.com9