Using the USB Duplicator
Main Menu
Compare
This function will compare the finished target USB flash drives to the source USB flash drive after copying is complete. The USB Duplicator supports Compare in both Synchronous, and Asynchronous modes.
Synchronous Compare
In Synchronous Compare all USB flash drives are compared simultaneously.
1.When copying is complete and with the data source drive and the target USB flash drives still loaded in the USB Duplicator, use the UP or DOWN arrow to scroll through the menu until Compare is displayed on the LCD screen.
USB Duplicator 2. Compare
OK
ENT ESC
ESC
2.Press the OK button on the display panel to select Compare. The LCD will display the following status:
USB (953M) | 925M |
3 ready |
|
|
|
OK
ENT ESC
ESC
3.Press OK again and the Compare will start as shown in the display below.
Compare 15%
925M | OK |
0:18 226M | ENT ESC |
ESC |
Note: When Compare is in process the Green LED on the front panel is blinking. Do not take out the drive while it is running a comparison. When Compare is finished the Green LED stays on (no blinking). If an error occurs during the copy process a Red LED will display.