Using the USB Duplicator
4.When Compare is complete the display will show the total, and the number that pass and fail.
Total OK: 5 | OK: 5 | NG: 0 |
1:03 | OK: 5 | NG: 0 |
|
|
|
OK
ENT ESC
ESC
Asynchronous Compare is used only when the source content is the same as or less than the system buffer (256MB). With the source content read into the systems buffer you can compare flash drives continuously by taking out the drive which has finished comparing, and replacing it with another flash drive. This process is repeated until the comparison job is complete.
1.Load the source flash drive into the USB Duplicator. Use the UP or DOWN arrow to scroll through the menu until Compare is displayed on the LCD screen.
USB Duplicator 2. Compare
OK
ENT ESC
ESC
2.Press the OK button on the display panel. The USB Duplicator will start to read the source content into the system’s buffer and immediately start comparing any loaded target USB flash drives.
USB(58M) 450M
Reading...
OK
ENT ESC
ESC
3.Load the target flash drives to be compared into the USB Duplicator. The LCD will display the number of flash drives loaded and comparing.
Pass: 0 | Working |
Fail: 0 | 3 |
|
|
OK
ENT ESC
ESC
Note: When compare is in process the Green LED on the front panel is blinking. Do not take out the drive while it is comparing. When comparing is finished the Green LED stays on (no blinking). If an error occurs during the process a Red LED will display.