Using the USB Duplicator
This function allows you to set the time to exit Asynchronous Copying when you pull all the USB flash drives out of the duplicator. The default setting is 30 seconds. If after 30 seconds no new drives are plugged into the USB Duplicator the LCD will ask to exit Asynchronous or to stay in Asynchronous mode. Press OK to exit Asynchronous Copying or press ESC to keep this status.
To change the default setting for Asyn Hold Time use the following procedure:
1.Use the UP or DOWN arrow to scroll through the menu until Setup is displayed on the LCD screen. Press the OK button to select.
USB Duplicator 7. Setup
OK
ESC
2.Use the UP or Down arrow to scroll through the Setup options until Asyn Hold Time is displayed on the LCD screen. Press OK.
7. Setup:
4. Asyn Hold Time
OK
ESC
3.Default setting is 30 seconds; press the arrow keys to change. Press ESC to exit.
OK
ESC
To make sure the FAT table of each flash drive was copied correctly all source and target flash drives should be the same capacity. Each flash drive potentially has some capacity difference due to the manufacturing process. To ensure both the source and target flash drives are at the same capacity you can set the capacity tolerance. This function is used to set the tolerance % of flash capacity difference between source and targets.
30www.aleratec.com