Main Menu

Asynchronous Copy+Compare

Asynchronous Copy+Compare is used only when the source content is the same as or less than the system buffer (256MB). With the source content read into the systems buffer you can copy and compare flash drives continuously by taking out the drive which has finished its Copy+Repair cycle, and replacing it with another blank. This process is repeated until the Copy+Compare job is complete.

1.Load the source flash drive into the USB Duplicator. Use the UP or DOWN arrow to scroll through the menu until Copy+Compare is displayed on the LCD screen.

USB Duplicator

3. Copy+Compare

OK

ENT ESC

ESC

2.Press the OK button on the display panel. The USB Duplicator will start to read the source content into the system’s buffer and immediately start copying any loaded target USB flash drives.

USB(58M) 450M

Reading...

OK

ENT ESC

ESC

3.Load the blank target flash drives into the USB Duplicator. The LCD will display the number of blank media loaded and copying.

Pass: 0

Working

Fail: 0

3

 

 

OK

ENT ESC

ESC

Note: When copying is in process the Green LED on the front panel is blinking. Do not take out the drive while it is copying. When copying is finished the Green LED stays on (no blinking). If an error occurs during the copy process a Red LED will display.

16www.aleratec.com