Chapter 12: User Diagnostics

Performing Diagnostics

At the MS-DOS prompt, type uxdiag followed by the command options.

The uxdiag command options are shown in Table 8. For example, to run all of the diagnostic tests except Group B tests on adapter #1, enter:

C:\>uxdiag -c 1 -t b

Note

You must include uxdiag at the beginning of the command string each time you type a command.

Table 8. uxdiag Command Options

Command Options

Description

 

 

uxdiag

Performs all tests on all Broadcom

 

NetXtreme II adapters in your system.

 

 

uxdiag -c <devnum>

Specifies the adapter (devnum) to test.

 

Use all in place of a specific device

 

number to test all adapters.

 

 

uxdiag -cof

Allows tests to continue after detecting

 

a failure.

 

 

uxdiag -F

Forces an upgrade of the image

 

without checking the version.

 

 

uxdiag -fbc <bc_image>

Specifies the bin file to update the

 

bootcode.

 

 

uxdiag -fib <ib_image>

Specifies the bin file for iSCSI boot.

 

 

uxdiag -fibc

Programs the iSCSI configuration

 

block. Used only with -fib <ib_image>.

 

 

uxdiag -fibp

Programs the iSCSI configuration

 

software. Used only with -fib

 

<ib_image>.

 

 

uxdiag -fipmi

Specifies the bin file to update IPMI

<ipmi_image>

firmware.

 

 

uxdiag -fmba

Specifies the bin file to update the

<mba_image>

MBA.

 

 

uxdiag -fncsi

Specifies the bin file to update the

<ncsi_image>

NCSI firmware.

 

 

158

Page 158
Image 158
Allied Telesis AT-2973SX, AT-2973T/4 manual Performing Diagnostics, uxdiag -c 1 -t b, Command Options Description