Allied Telesis AT-2973T/4, AT-2973SX manual Installing a Network Adapter Card

Chapter 2: Installing the Hardware

Installing a Network Adapter Card

The following instructions apply to installing the AT-2973SX, AT-2973T, and AT-2973T/4 adapters in most systems. For details about performing these tasks on your particular system, refer to the manuals that were supplied with your system.

Note

To perform this procedure, you need to supply a Phillips-head screw.

Note

The AT-2973SX, AT-2973T, and AT-2973T/4 adapters require a

PCIe x4 PC.

To install an AT-2973SX, AT-2973T, or AT-2973T/4 adapter, do the following:

1.Review the “Pre-Installation Checklist” on page 31 and “Reviewing Safety Precautions” on page 29.

Before installing the adapter, ensure the system power is OFF and unplugged from the power outlet, and that proper electrical grounding procedures have been followed.

Warning

High voltage inside the system presents a safety hazard. Make sure the power is off before removing the cover.

2.Remove the system cover and select any appropriate empty PCI slot. See Figure 9 on page 35.

If you do not know how to identify an appropriate PCI slot, refer to the system documentation that was included with your PC.

34