Sound Setting
Rotary SOURCE/
encoder POWER BAND MENU
MODE
Adjusting Bass/Treble/Balance (Between
Left and Right)/Fader (Between Front
and Rear)/Defeat
1 Press MODE repeatedly to choose the desired mode.
Each press changes the modes as follows:
BASS 
TREBLE 
SUBW* 
BALANCE 
FADER 
DEFEAT 
VOLUME 
BASS
Bass Level:
Treble Level:
Subwoofer : 0 ~ +15
Balance : L15 ~ R15
Fader : R15 ~ F15
Defeat : ON/OFF
Volume : 0 ~ 35
•If MODE is not pressed within 5 seconds after selecting the BASS, TREBLE, BALANCE, FADER, DEFEAT or SUBW mode, the unit automatically returns to normal mode.
* When the subwoofer mode is set to OFF, its level cannot be adjusted.
2 Turn the Rotary encoder until the desired sound is obtained in each mode.
By setting Defeat ON, previously adjusted settings of BASS and TREBLE will return to the factory defaults.
•Depending on the connected devices, some functions and display indications do not work.
Setting the Bass Control
You can change the Bass Frequency emphasis to create your own tonal preference.
1 Press MENU to select the BASS ENGINE mode, then press MODE.
BASS ENGINE 
SETUP 
RETURN (OFF) 
BASS ENGINE
2 Press 
or 
to select the BASS (bass Centre frequency) control mode.
BASS 
TREBLE
Setting the Bass Centre Frequency
80Hz 
100Hz 
120Hz 
60Hz 
80Hz
Emphasizes the displayed bass frequency ranges.
Setting the Bass Bandwidth
3-2 Press BAND to select the desired bass bandwidth.
Changes the boosted bass bandwidth to wide or narrow. A wide setting will boost a wide range of frequencies above and below the centre frequency. A narrower setting will boost only frequencies near the centre frequency.
