System Example
Connect the
System switch | EQ/DIV |
|
|
Video output Lead (Yellow)
Remote control input Lead (White/Brown)
Monitor control Lead (White/Pink)
To Digital output terminal
Fiber optic Cable
Video input terminal
RCA Extension cable (video) (included)
Remote control output Lead (White/Brown)
Monitor control Lead (White/Pink)
Touch panel compatible monitor box (sold separately)
Touch panel compatible monitor (sold separately)
Fiber optic input terminal (for head unit) |
| |||||||||
audio processor |
| |||||||||
|
|
|
|
|
|
|
| (sold separately) | ||
|
|
|
|
|
|
|
| (Fiber optic compatible) | ||
|
|
|
|
|
|
|
|
|
|
|
•When the fiber optic compatible product is connected, it is necessary to set the mode of this unit. Refer to “Setting the Digital Output” (page 30) and set to ON.
Please observe the following when using Fiber Optic Cable.
•Be careful not to bend the fiber optic cable at a sharp angle.
•Do not coil the fiber optic cable smaller than a 30 mm radius.
•Do not place anything on top of the fiber optic cable.
Fiber optic input terminal
(for changer)
*
Fiber optic cable
* Only connect fiber optic compatible CD changer
To prevent external noise from entering the audio system.
•Locate the unit and route the leads at least 10 cm away from the car harness.
•Keep the battery power leads as far away from other leads as possible.
•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.
