Button Labelling
3.Install the Key Cap on the pushbutton (FIG. 3):
Key Cap - tilted so that the bottom of the Cap is placed on the bottom of the pushbutton first
At this point, do not allow the clips
on the sides of the Key Cap to engage
Clip |
| 1 |
|
Clip
Pushbutton on keypad 
Press the top of the Key Cap |
|
down to engage both clips at |
|
once, securing the Key Cap | 2 |
to the pushbutton |
Once the clips are engaged, | 3 |
the Key Cap is secured |
|
to the pushbutton
FIG. 3 Placing a Button Label inside a Key Cap
Verify that the vertical orientation of the Button Label is correct relative to the keypad.
a.Gently press the bottom of the Key Cap (no clip) onto the pushbutton. Do not allow the clips on either side to engage.
b.With the bottom of the Key Cap secured, gently press the top of the Key Cap. This action will engage both clips simultaneously, and the Key Cap will snap into place on the push button.
Be careful to follow these procedures closely - the bottom of the Key Cap must be installed on the pushbutton before the Key Cap clips engage, or there is a risk of the button being misaligned.
Also note that removing the Key Caps requires additional steps - see the Removing/ Replacing Button Labels section on page 39 for details.
38 | Novara ControlPads & KeyPads |
