AMX NI-3101-SIG manual SET IO Link, SET Mode, Short cable length 10 feet, Xch

Programming

IR/Serial Send_Commands (Cont.)

Command	Description
SET IO LINK	The I/O status is automatically reported on channel 255 on the IR port. The I/O
Link an IR or Serial port to a	channel is used for power sensing (via a PCS or VSS). A channel of zero
selected I/O channel for use	disables the I/O link.
with the 'DE', 'POD', 'PON',	Syntax:
and 'POF' commands.	SEND_COMMAND <DEV>,"'SET IO LINK <I/O number>'"
	Variable:
	I/O number = 1 - 8. Setting the I/O channel to 0 disables the I/O link.
	Example:
	SEND_COMMAND IR_1,"'SET IO LINK 1'"
	Sets the IR_1 port link to I/O channel 1. The IR port uses the specified I/O input
	as power status for processing 'PON' and 'POF' commands.
SET MODE	Sets an IR port to either IR, Serial, or Data mode.
Set the IR/Serial ports for IR	Note: IR DATA Mode works best when using both a lower baud rate and a
or Serial-controlled devices	short cable length (< 10 feet).
connected to a CardFrame or	Syntax:
NetModule.	SEND_COMMAND <DEV>, 'SET MODE <mode>'"
	Variable:
	mode = IR, SERIAL, or DATA.
	Example:
	SEND_COMMAND IR_1,"'SET MODE IR'"
	Sets the IR_1 port to IR mode for IR control.
SP	You can use the 'CTON' to set pulse lengths and the 'CTOF' for time Off
Generate a single IR pulse.	between pulses.
	Syntax:
	SEND_COMMAND <DEV>,"'SP',<code>"
	Variable:
	code = IR code value 1 - 252 (253-255 reserved).
	Example:
	SEND_COMMAND IR_1, "'SP',25"
	Pulses IR code 25 on IR_1 device.
XCH	Syntax:
Transmit the selected chan-	SEND_COMMAND <DEV>,"'XCH <channel>'"
nel IR codes in the format/	Variable:
pattern set by the 'XCHM'	channel = 0 - 999.
send command.	Example:
	For detailed usage examples, refer to the 'XCHM' command.

140 NI-3101-SIG Signature Series NetLinx Integrated Controller