AMX NI-3101-SIG Resetting the Factory Default System and Device Values, Example Previous DS=50011

Configuration and Firmware Update

Identify Mode is currently active

FIG. 19 Device Addressing dialog - Identify Mode active

5.Press the NI Controller’s ID button to assign the new Device / System values entered in step 3 to the Controller. At this point, the "Successful Identification Made " message is displayed (FIG. 20):

Device identified

ID Mode no longer active

FIG. 20 Device Addressing dialog - Successful Identification Made

The previous Device and System numbers of the NI Controller are displayed below the red field.

Example: Previous D:S=5001:1,

where "5001" represents the previous device value of the NI Controller (D) and "1" represents the NI Controller’s System value (S).

Resetting the Factory Default System and Device Values

1.Access the Device Addressing dialog (FIG. 17 on page 20) by either one of these two methods: Right-click on any system device listed in the Workspace and select Device Addressing.

Select Diagnostics > Device Addressing from the Main menu.

2.Click the Set Device/System to Factory Default button. This resets both the system value and device addresses (for definable devices) to their factory default settings. The system information (in the OnLine Tree tab of the Workspace window) refreshes and then displays the new information.

22 NI-3101-SIG Signature Series NetLinx Integrated Controller