AMX NI-3101-SIG manual Master IP Local Port SendCommands, Using the ID Button

Programming

Master IP Local Port Send_Commands

These commands are specific to the Master and not the Controller. These commands are sent to the DPS 0:1:0 (the Master). A device must first be defined in the NetLinx programming language with values for the Device: Port: System.

In these programming examples, <DEV> = Device. The term <D:P:S> = Device:Port:System.

Master IP Local Port Send_Commands

Command	Description
UDPSENDTO	This is only available for Type 2 and Type 3 Local Ports. Type 2 and Type 3 are
Set the IP and port number of	referring to the protocol type that is part of the IP_CLIENT_OPEN call (4th
the UDP local ports	parameter).
destination for sending future	Type 1 is TCP.
packets.	Type 2 is UDP (standard)
	Type 3 is UDP (2 way)
	The NetLinx.axi defines constants for the protocol types:
	CHAR IP_TCP = 1
	CHAR IP_UDP = 2
	CHAR IP_UDP_2WAY = 3
	Syntax:
	SEND_COMMAND <D:P:S>,"'UDPSENDTO-<IP or URL>:<UDP Port Number>'"
	Variables:
	IP or URL = A string containing the IP Address or URL of the desired
	destination.
	UDP Port Number = A String containing the UDP port number of the desired
	destination.
	Example 1:
	SEND_COMMAND 0:3:0,"'UDPSENDTO-192.168.0.1:10000'"
	Any subsequent SEND_STRING to 0:3:0 are sent to the IP Address
	192.168.0.1 port 10000.
	Example 2:
	SEND_COMMAND 0:3:0,"'UDPSENDTO-myUrl.com:15000'"
	Any subsequent SEND_STRING to 0:3:0 are sent to the URL myURL.com port
	15000.

Using the ID Button

The ID Button on the rear panel of the Integrated Controller is used in conjunction with the NetLinx Studio 2.x software program to allow you to assign new Device and System numbers for the Integrated Controller.

1.Using NetLinx Studio 2.x, place the system in Identity (ID) Mode. ID Mode means the entire system is put on hold while it waits for an event from any NetLinx device in the named system (for example, pushing the ID button on the Integrated Controller). The device that generates the first event is the identified device.

2.Press the ID Mode button to generate an event from the Integrated Controller and assign new device and system numbers in NetLinx Studio.

Only the Device number can be changed on the Controllers using the ID button. Port and System can not be defined.

NI-3101-SIG Signature Series NetLinx Integrated Controller 117