AMX NI-3101-SIG manual Subnet Mask, and Gateway IP Address

Programming

Configuration Port Commands (Cont.)

Command	Description
SET HTTPS PORT	Sets the IP port listened to for HTTPS connections.
	Example:
	>SET HTTPS PORT
	Current HTTPS port number = 443
	Enter new HTTPS port number (Usually 443) (0=disable HTTPS)
	:
	Once you enter a value and press the ENTER key, you get the following
	message:
	Setting HTTPS port number to
	New HTTPS port number set, reboot the master for the change
	to take affect.
SET ICSP PORT	Sets the IP port listened to for ICSP connections.
	Example:
	>SET ICSP PORT
	Current ICSP port number = 1319
	Enter new ICSP port number (Usually 1319) (0=disable ICSP)
	:
	Once you enter a value and press the ENTER key, you get the following
	message:
	Setting ICSP port number to
	New ICSP port number set, reboot the master for the change
	to take affect.
SET ICSP TCP TIMEOUT	Sets the timeout period for ICSP and i!-WebControl TCP connections.
	Example:
	>SET ICSP TCP TIMEOUT
	This will set the timeout for TCP connections for both ICSP
	and i!-WebControl.When no communication has been detected for
	the specified number of seconds, the socket connection is
	closed.ICSP and i!-WebControl have built-in timeouts and
	reducing the TCP timeout below these will cause undesirable
	results. The default value is 45 seconds.
	The current ICSP TCP timeout is 45 seconds
	Enter new timeout (in seconds):
	Once you enter a value and press the ENTER key, you get the following
	message:
	New timeout value set (in affect immediately).
SET IP <D:P:S>	Prompts you to enter a Host Name, Type (DHCP or Fixed), IP Address,
	Subnet Mask, and Gateway IP Address.
	Enter Y (yes) to approve/store the information into the Master.
	Entering N (no) cancels the operation.
	Example:
	>SET IP [0:1:0]
	--- Enter New Values or just hit Enter to keep current
	settings ---
	Enter Host Name:	MLK_INSTRUCTOR
	Enter IP type. Type D for DHCP or S for Static IP and then
	Enter: DHCP
	Enter Gateway IP:	192.168.21.2
	You have entered: Host Name		MLK_INSTRUCTOR
		Type	DHCP
		Gateway IP	192.168.21.2
	Is this correct? Type Y or N and Enter -> y
	Settings written. Device must be rebooted to enable new
	settings.

124 NI-3101-SIG Signature Series NetLinx Integrated Controller