Connecting outputs
Connecting to other equipment
Monitor output
Both composite and
to your AVR100 you need only connect the
Connecting to a power supply
Wrong plug?
Check that the plug supplied with the unit fits your supply and that your mains supply voltage agrees with the voltage setting (120V or 230V) indicated on the rear panel of the unit.
If your mains supply voltage or mains plug is different, consult your Arcam dealer or Arcam Customer Support on +44 (0)1223 203203.
Loudspeaker outputs
Before connecting loudspeakers to your AVR100 you must set the Impedance switch on the rear to the correct position.
WARNING: Never adjust this switch with the power on or you will damage the AVR100.
If your loudspeakers are rated at 6Ω or lower set the switch to the
WARNING: This unit should only be used with loudspeakers with an impedance rating between 4Ω and 8Ω.
The AVR100 is fitted with loudspeaker terminals in line with BFA (British Federation of Audio) standard specification. The terminal will accept spades, bare wire or a BFA plug. To connect spades or bare wires, unscrew the end of the terminal, insert the wire or spade and screw back up. Ensure that no stray strands of wire are allowed to touch other cables or the AVR100’s casing as this can cause a short circuit and damage the amplifier.
Bi-wiring and Bi-amping loudspeakers
Notes on these techniques are given in the Reference section of this handbook.
Preamplifier outputs
If you wish to upgrade your system by adding a power amplifier, always specify an Arcam unit to ensure matching gain.
The AVR100 has six
Depending on how your system is configured, the subwoofer
■an active subwoofer, or
■a power amplifier used to drive a passive subwoofer.
Headphone output
A 1/4” stereo jack socket is provided on the front panel for headphone listening. Inserting the jack socket automatically mutes the loudspeaker and
Mains lead
The appliance is normally supplied with a moulded mains plug already fitted to the lead. If for any reason the plug needs to be removed, it must be disposed of immediately and securely, as it is a potential shock hazard when inserted into the mains socket. Should you require a new mains lead, contact your Arcam dealer.
Plugging in
Push the plug (IEC line socket) of the power cable supplied with the unit into the socket (AC INLET) in the back of the unit. Make sure it is pushed in firmly.
Put the plug on the other end of the cable into your power supply socket and switch the socket on.
Non-use periods
If the unit is to be left unused for an extended period, we recommend that you switch the unit off from the front panel button, rather than use ‘stand by’ mode with the remote control.
AVR100
6