AUDIX Voice Power Initial Implementation

Verifying System Parameters

After the first two groups of system parameters (Voice Mail and Automated Attendant parameters) have been determined and entered on FORM C, review them. Then add the Message Waiting Lamp parameters to the third section of FORM C in the Planning Guide and enter the parameters into the AUDIX Voice Power system.

You will need two pieces of information:

whether or not the message waiting lamps are to be used

the System 75 or DEFINITY G1 message waiting lamp codes if they have been changed from the default

Verifying Message Waiting Lamp Parameters

Message Waiting Lamp parameters affect only the operation of message waiting lamps. The following parameters are available:

Code to Light specifies the internal code that AUDIX Voice Power sends to the switch to light the message waiting lamp. Enter the value found on the Feature Access Code form or leave the field blank if message waiting lamps will not be used.

Code to Extinguish specifies the internal code that AUDIX Voice Power sends to the switch to extinguish the message waiting lamp. Enter the value found on the Feature Access Code form or leave the field blank if message waiting lamps will not be used.

Refresh indicates whether you wish to have message waiting lamps refreshed at predetermined intervals. Enter y if message waiting lamps are used, or n if message waiting lamps will not be used.

Page 38
Image 38
AT&T 2.1.1 manual Verifying System Parameters, Verifying Message Waiting Lamp Parameters