Aurora Electronics PVI-3600-OUTD-UK-F-W manual

Installation and Operator’s Manual	Page 20 of 63
(PVI-3600-OUTD-UK-F-W Rev.: 1.0)

Install the expansion screws in the wall so that the head of the screws is about 4mm from the wall surface. Then hang AURORA on the wall by fitting the screw heads in the mounting slots as shown in Fig.7, and secure the screws.

Fig.7 AURORA wall mounting

It is possible to mount AURORA in a tilted position. In that case the thermal dissipation will not be optimized and the cooling fan may start at lower ambient temperatures than the pre-set intervention threshold.

NOTE: In case of installation of several units, MAGNETEK recommends not to install them in parallel, superimposed, rows.

In fact the heat generated by the bottom rows will get the ambient temperature of the upper inverters to increase. At ambient temperatures