Installation and Operator’s Manual | Page 5 of 63 |
|
In particular, during transport and handling, parts shall not be bent and/or the insulation distances shall not be changed. There should be no contact between electronic parts and connection terminals.
Electrical parts must not be mechanically damaged or destroyed (potential health risk).
ELECTRICAL CONNECTION
With the inverter powered, comply with all prevailing national regulations on accidents prevention.
Electrical connections shall be carried out in accordance with the applicable regulations, such as conductor sections, fuses, PE connection.
OPERATION
Systems equipped with inverters shall be provided with further control and protective devices in compliance with the corresponding prevailing safety rules, such as those relating to the compliance with technical equipment, accident- preventing regulations, etc. Any calibration change shall be made using the operational software. Once the inverter has been disconnected from the power grid, powered parts and electrical connections shall not be touched as some capacitors could be charged.
Comply with all corresponding marks and symbols present on each device. During operation, make sure that all covers and doors are closed.
MAINTENANCE AND SERVICE
Comply with manufacturer’s recommendations.
