Page 12 - Installing Software Upgrade |
| Software Upgrading and Installation | |
|
|
|
|
Upgrade Steps |
| Explanation |
|
Step 13 |
| Note: |
|
Once the IPNC has been restarted load the IPNC |
|
| |
3.x firmware using the Manger UpgradeWize |
| Loader v1.7 is compatible with IPNC 2.2 or 3.2 |
|
(FileAdvancedUpgrade). |
| software for operational use. If IPNC 3.2 is to |
|
In step 2, the nadrcii.bin was renamed nadrcii.old. |
| be loaded then the loader must be v1.7. |
|
For the 3.2 version of IPNC firmware this must be |
| When the upgrade via the wizard shows the |
|
renamed back from nadrcii.old to nadrcii.bin. The |
| rebooting sequence. |
|
2.2(1076) bin file can be renamed appropriately. |
| If the upgrade process finishes and says it has |
|
|
| failed, ignore and press OK. |
|
|
|
|
|
Step 14 |
|
|
|
Check the firmware variant by opening the upgrade |
| To prove that upgrade is successful use the |
|
wizard again and see the Unit build number (3.2/19) |
| Refresh button on the Upgrade Wizard to |
|
|
| update the display. |
|
|
| Confirm that the version shown in the Version |
|
|
| column is the same as that shown in the |
|
|
| Available column. |
|
|
|
|
|
Step 15 |
| When connecting for the first time via the |
|
Restart the IPNC with 3.2 software and ensure that |
|
| |
it is defaulted to factory settings as follows: |
| Manager after defaulting, please check that |
|
Using IPNC Manager: |
| the DHCP Server address range is 200 to |
|
Open FileAdvancederaseConfig (factory Default). |
| LAN 1 and LAN 2. |
|
Or |
| If these are blank then DHCP will fail. |
|
Using HyperTerminal: |
|
|
|
Unplug the IPNC. Plug in the IPNC and press the |
|
|
|
'Ecs' key every second until the Loader message |
|
|
|
appears. |
|
|
|
Enter AT return |
|
|
|
Enter |
|
|
|
Enter |
|
|
|
Unplug the IPNC and plug in again. |
|
|
|
|
|
|
|
Page 12 - Software Upgrading and Installation | INDeX IPNC Cassette Administration Manual |
Installing Software Upgrade | 38DHB0002UKDD – Issue 7 (22/11/02) |