Software Upgrading and Installation | Introduction - Page 9 |
Software Upgrading and Installation
Introduction
The installation Wizard installs the IPNC Manager application on the Administration PC.
Notes: 1. The Configuration Wizard is contained on the Administration Software CD (which can also be accessed by running Setup.exe). The CD will auto run unless this feature has been disabled on the PC.
2.The IPNC Manager application is common to both INDeX IPNC and Avaya IP Office systems. However, the IPNC Manager application must not be installed on a PC being used to administer an Avaya Alchemy system.
Installing Software Upgrade
The following details the steps necessary to upgrade an IPNC 2.2 to 3.2 software.
To do this, it is necessary to first load IPNC 2.2 (1076) software to update the IPNC loader firmware to version 1.7, which is required in order to load IPNC 3.2 software.
CAUTION: Before upgrading to 3.2 software, you must make a hard copy of the existing 2.2 configuration. This is necessary because, once the
3.2software has been loaded, it is not possible to reload an existing
2.2configuration file. The existing 2.2 configuration can then be re- typed into the 3.2 Manager application.
Notes: 1. In the following, all commands in bold type are case sensitive and should be entered as specified.
2. In the following, it is assumed that the CD is in Drive D.
| Upgrade Steps |
|
| Explanation |
|
| Step 1 |
|
| In order to access the DTE port the |
|
| Connect a terminal to the IPNC’s DTE maintenance |
|
|
| |
| port (see page 6). |
|
| HyperTerminal must be configured to operate |
|
| Open HyperTerminal (or similar) to communicate |
|
| as follows:- |
|
| with the IPNC. |
|
|
|
|
| Type at to test the connection. |
|
| 38400, 8, N, 1 |
|
| The IPNC should return, ‘OK’ if the terminal is |
|
|
|
|
| correctly configured. |
|
|
|
|
| Step 2 |
|
| In case it is necessary to abort the upgrade |
|
| Save the current IPNC 2.2 configurations files to a |
|
|
| |
| new folder. |
|
| and return to the 2.2 build, you will need the |
|
| Make a hard copy of the existing 2.2 configurations. |
|
| configuration files. |
|
|
|
| This hard copy will be needed for |
| |
|
|
|
|
| |
|
|
|
|
| |
|
|
|
|
|
|
INDeX IPNC Cassette Administration Manual | Software Upgrading and Installation - Page 9 |
38DHB0002UKDD – Issue 7 (22/11/02) | Introduction |