Avaya 38DHB0002UKDD manual Dynamic IP Addressing

Page 14 - Installation of a New System Software Upgrading and Installation

Dynamic IP Addressing

The following paragraphs detail the configuration requirements for dynamic IP addressing of the Administration PC which will be used to configure the IPNC.

To examine the IP configuration, use Start/Run/winipcfg (Windows 95/98). On win 2000/NT/XP use the DOS command ipconfig; this command is used

To change to DHCP/automatic addressing either:

For Windows 95/98: Right-click on the Network Neighbourhood icon or use Start Settings Control Panel and double-click on the Network icon. From the Network Configuration panel, select the TCP/IP protocol and click on Properties. In the Properties panel, shown below, click on Obtain IP Address Automatically. It may then be necessary to re-boot the PC to implement the change.

Or

For Win 2000/NT/XP: Use Start Settings Control Panel and double click on the Network and Dial-up Connections icon. Select the Local Area Connections icon, right click and select Properties. Highlight the Internet Protocol icon and select Properties again.

In the Properties panel, shown below, click on Obtain IP Address Automatically. It may then be necessary to re-boot the PC to implement the change.

Win 95/98 Win 2000/NT/XP

For a dynamic addressing/DHCP network, the winipcfg Release All and Renew All buttons can be used to change the adapter’s IP address, (without the need to re-boot). For Windows NT, at the system prompt, use IPConfig /Release and IPConfig/Renew instead of Winipcfg.

Page 14 - Software Upgrading and Installation	INDeX IPNC Cassette Administration Manual
Installation of a New System	38DHB0002UKDD – Issue 7 (22/11/02)