Avaya 38DHB0002UKDD Erasing/Re-InstallingOperational Software, Appendix D: Use Of The Serial Port

Appendix D: Use Of The Serial Port Erasing/Re-Installing Operational Software - Page 131

Erasing/Re-Installing Operational Software

It may be necessary to carry out this procedure because the software is corrupted.

Note: A replacement copy of software is installed from the Manager PC via the LAN, so ensure that the PC is connected and the Manager is running.

Proceed as Steps 1 and 2 above, type AT-X[Enter] and wait whilst the memory is erased and the new software loaded, as shown below.

Replacing the Operational Software in Flash Memory

Loader 1.1 DualFlash (2MB-2xF800 Flash-120nS DRAM-70nS EDO)

AT

OK

AT-X

Multi-Sector Erase

OK

Received BOOTP Response :C0.A8.2A.01 IPNC.bin

TFTP Load Start

TFTP Load complete

Note: The command View/TFTP Log used immediately after the AT-X command shows the BootP request sent to the Manager and the progress of the download:

:Received BOOTP request for 00e007000123 192.168.42.1 IPNC.bin

:Sending BOOTP response for 00e007000123 192.168.42.1 IPNC.bin

:Sending IPNC.bin length 654321 bytes to 192.168.42.1

:Sent 10% of IPNC.bin

:Sent 20% of IPNC.bin

:Sent 30% of IPNC.bin

:Sent 40% of IPNC.bin

:Sent 50% of IPNC.bin

:Sent 60% of IPNC.bin

:Sent 70% of IPNC.bin

:Sent 80% of IPNC.bin

:Sent 90% of IPNC.bin

:Sent 100% of IPNC.bin

:Sent IPNC.bin length 654321 bytes

INDeX IPNC Cassette Administration Manual	Appendix D: Use Of The Serial Port - Page 131
38DHB0002UKDD – Issue 7 (22/11/02)	Erasing/Re-Installing Operational Software