Self-Test Procedure

The single-digit value is represented by Call Appearance Line a, which winks the number of times represented by the current L2Q value 600 milliseconds on, 200 milliseconds off. If the current value is zero (AUTO), Call Appearance Line a’s indicator flutters five times 50 milliseconds on, 50 milliseconds off instead of winking.

After “displaying” the current L2Q value, the Message Waiting indicator at the top of the telephone and the Message button LED on the faceplate flash 500 milliseconds on, 500 milliseconds off to indicate an entry is expected.

2.Enter a valid value (1, 2, or 0) for the L2Q (802.1Q) framing parameter.

The 4601 provides feedback for the digit as you enter it using Call Appearance Line a. For example, if the L2Q value is “2,” pressing the number 2 on the dial pad causes Call Appearance Line a’s indicator to wink two times. Pressing “0” (zero) on the dial pad causes Call Appearance Line a’s indicator to flutter three times 50 milliseconds on, 50 milliseconds off.

Then both Message Waiting indicators flash 500 milliseconds on, 500 milliseconds off to indicate an entry is expected.

3.Press the * button to terminate the procedure, or the # button to save the new value. If you press the # button, the 4601 saves the new value, and resets the telephone to restore the user interface to its previous state.

Self-Test Procedure

For self-testing, use the following procedure:

1.To invoke 4600 Series IP Telephone self-test procedures, press the following sequence of keys on the faceplate of the telephone:

Mute 8 3 7 8 # (Mute T E S T #)

Note:

Press the Mute button momentarily. Do not press this button while pressing other keys/buttons. The 4630 and 4630SW IP Telephones do not have a dedicated Hold button. For all other 4600 Series IP Telephones, pressing the Hold button instead of the Mute button also works. The 4690 IP Conference Telephone does not support this feature.

For the 4606, 4612, and 4624 IP Telephones, the telephone illuminates each column of red and green LEDs associated with administrable buttons sequentially for 0.5 second, from left to right across the telephone. This cycle then repeats. The Speaker/Mute LED and the message waiting LED illuminate along with the closest column of LEDs. Buttons generate a button click if pressed, but do not generate any system-specific signaling messages, DTMF, or invoke Speaker or Mute operation.

Issue 6 February 2007 81

Page 81
Image 81
Avaya 555-233-128 manual Self-Test Procedure, Mute 8 3 7 8 # Mute T E S T #