Scenarios for the Restart Process

4.When control is passed to the software that was just loaded, the following messages display:

Starting...

Updating boot code...

DO NOT UNPLUG THE

PHONE!

This message continues while the new boot code is being written into RAM.

Note:

Unplugging the telephone while the flash memory is being erased and the boot code rewritten can cause file corruption.

5.The telephone detects and displays the speed of the Ethernet interface in Mbps, that is, 0, 10, or 100. The message No Ethernet displays until the software determines whether the interface is 10 Mbps or 100 Mbps.

Note:

The Ethernet speed indicated is the LAN interface speed for both the telephone and any attached PC.

6.The software determines whether sufficient IP Address information was downloaded. In this scenario, it is discovered that sufficient information has not been downloaded. The following message displays while the DHCP process is invoked:

DHCP: 0 secs * to program

The number of elapsed seconds is incremented once per second, until DHCP successfully completes.

7. The following message displays while the TFTP or HTTP process is invoked:

TFTP: n

www.xxx.yyy.zzz

HTTP: n uri

The number increments once per second, until the TFTP or HTTP server responds.

8.The following message displays while the upgrade script downloads from the TFTP or HTTP server:

46XXUPGRADE.SCR n KB received

where n is the number of KBs that have been downloaded.

Issue 6 February 2007 97

Page 97
Image 97
Avaya 555-233-128 manual Starting Updating boot code, Dhcp 0 secs * to program, Tftp n Http n uri