Baldor Device Net Expansion Board, EXB013A01 manual Sens

H Series – Fault Message Description Continued

Fault Message	Fault Code		Fault Description
	15H	18H
∝ p Reset	22	22	A software watchdog timer has reset the
			processor because a process has timed out.
ROM Fault		23	ROM checksum error.
1 Min Overload	24	24	Peak output current exceeded the 1 minute
			rating value.
No I Feedback		25	Loss of current feedback
New Base ID	26	26	Control board detected a change in the Power
			Base ID value in software.
EXB Selection	27	27	Expansion board not installed to support the
			Level 1 Input Block, Command Select
			parameter.
Power module		28	Power module failure.
Co–processor		29	Co–processor error (i.e. DSP board).
Software		30	Wrong control software version detected.
Version
Feedback		31	Feedback HW module failure.
Module
Serial watchdog		32	Serial port transmit/receive error
FLT Network	33	33	Lost network communications.
Hardware	54		A general hardware fault was detected but
Protect			cannot be isolated.
Unknown FLT	55	34	Microprocessor detected a fault that is not
Code			identified in the fault code table.
Bus Current	56		Failure to sense bus current.
SENS

Note These faults may be different for custom software.

6-24 Command Language