Baldor EXB013A01, Device Net Expansion Board manual Fault Code Fault Description 15H 18H, Flt

H Series – Fault Message Description

Fault Message	Fault Code		Fault Description
	15H	18H
Line Regen	1	1	Fault in Line REGEN converter unit -
			Series 21H Line REGEN Inverter control.
Feedback Fault		2	Loss of encoder feedback.
Invalid Base ID	3	3	Failed to read configuration from the Power
			Base ID value in software.
Low INIT Bus V	4	4	Low bus voltage detected on start–up.
Regen Res	5	5	Excessive power dissipation required by
Power			Dynamic Brake Hardware.
Current SENS	6	6	Failure to sense phase current.
FLT
HW	7	7	High output current condition detected (greater
Desaturation			than 400% of rated output current).
HW Ground	8	8	Ground Fault detected (output current leakage
Fault			to ground).
Resolver Fault		9	Loss of resolver feedback.
HW Power	10	10	Control Board power supply failure detected.
Supply
Overcurrent	11	11	Continuous current limit exceeded.
Bus	12	12	High DC Bus voltage.
Overvoltage
Following ERR		13	Motor speed/position does not follow command.
Torque Prove		14	Unbalanced current between all 3 phases.
Bus	15	15	Low DC Bus voltage condition detected.
Undervoltage
3 Sec Overload	16	16	Peak output current exceeded the 3 second
			rating value.
Over Speed		17	Motor RPM exceeded 110% of MAX Speed.
Motor Temp		18	Motor over temperature
Heatsink Temp	19	19	Control heatsink exceeded temperature limit.
External Trip	18	20	Connection at J1/J4 pin 16 and 17 is open.
Param	51	21	Parameter checksum error.
Checksum

Command Language 6-23