25
NT4 and 2000 only
9.Repeat the right hand mouse click over the printer icon and go to “Document defaults” and make sure the paper size is set to A4 then click “OK”. Also check the Port settings of your computer to make sure that “enable byte counting” is switched on..
Operating Instructions
10.For comprehensive operating instructions, please refer to the manual, which can be found on the CD that came with your unit.
Problems?
No Network Connection
1.Check the obvious things; is the unit switched on and
2.Check the cable connections and if possible use a known good cable and network port.
3.Have you programmed the IP address of the copier,
4.Even if you don’t have a Gateway, an address must be inputted. Choose a spare IP address for the Gateway if required.
5.Have you properly configured the LPR port on your PC? Again, refer to the start of this guide to check this.
6.Where you plug the network cable into the back of the copier, do you have a green “link light” showing. If not try an alternative network port. If you do not get a green link light, please contact your Dealer for further assistance.
7.If you do have a green “link light”, try to “ping” the network card in the copier by typing the following from a DOS prompt on your PC:
Ping 192.168.10.1
(Please substitute the IP address with the correct address you are using)
8.If you get a “reply” then you have a network connection. Double check numbers 1 through 5 and if necessary,
9.If you do not get a “reply” contact your Dealer for further assistance.
30/05/02 | Document Systems Support V1.0 |
