DS72 Host Module
DS72 External Modem Configuration
The DS72 network controller module can be controlled remotely by an external modem. To achieve this level of access please follow the instructions listed below.
DS72 Setup
The DS72 needs the DCD configured properly to work with an external modem. To configure the DCD:
1.Power down the DS base unit.
2.Remove the DS72 network controller.
3.While holding the face plate in your right hand locate the
4.Locate where the
5.Locate the DCD In/Out jumpers on either side of the
6.Move the DCD In jumper from GND to DCD In. See Figure 1
7.Place the DS72 controller back into the base unit.
8.Power up the base unit.
External Modem Setup
The external modem has to have a certain configuration for it to function properly with the DS72. Verify the following Configuration:
1.Data Terminal Ready (DTR) Normal
2.Verbal Result Codes
3.Suppress Result Code
4.No Echo
5.Auto Answer 1st Ring
6.Carrier Detect (CD) Normal
7.Load NVRAM Defaults
8.Smart Mode
Cabling
Make sure that the proper cabling is being used to connect the external modem to the serial port on the DS72. In most cases the combination of the
35
