BenQ W5000 Adjusting the projected image, Adjusting the projection angle, Two parallel sides

Models: W20000 W5000

1 53
Download 53 pages 17.21 Kb
Page 23
Image 23

W20000-en.book Page 23 Monday, October 22, 2007 3:35 PM

Adjusting the projected image

Adjusting the projection angle

There are four adjuster feet on the bottom of the projector. These can be used if necessary to change the projection angle. Screw the feet in or out as appropriate to aim and level the projection angle.

If the screen and the projector are not perpendicular to each other, the projected image becomes vertical trapezoidal. To correct this problem, see "Correcting picture distortion" on page 23 for details.

Correcting picture distortion

Keystoning occurs when the projector is not perpendicular to the screen and is where the projected picture displays visible as a trapezoid shape like either of the following:

Two parallel sides (left and right, or top and bottom) but is noticeably wider on either side.

No parallel sides.

To correct the picture's shape, you can perform the following steps.

1.Adjust the projection angle. Move the projector to be in front of the center of the screen with the base of the lens level with the top or bottom edge of the screen.

2.If the picture is stilled distorted, or the projector is unable to be positioned as described above, you will need to manually correct the picture.

English

Using the remote control or projector

i.Press one of the Arrow keys on the remote control ( , ) or

projector ( / , / ) to display the Keystone page.

ii.See step iv below for further operation.

Using the OSD menu

i.Press MENU and then press / until the Display menu is highlighted.

ii.Press to highlight Keystone and press ENTER. The Keystone page displays.

iii.Highlight 2D Keystone and press ENTER. The keystone correction page displays.

iv.Press the key whose keystone icon is similar to the shape of the projected picture. Continue pressing the same key or press the other keys until you are satisfied with the shape.

The values on the lower portion of the page change while pressing. When the values reach their maximum or minimum with repeated key presses, the picture's shape will stop changing. You will not be able to change the picture further in that direction.

Two parallel sides

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Press .

 

 

 

 

 

Press .

No parallel sides

2

3

 

1

 

 

ENTER

 

 

Display

 

 

Aspect Ratio

Anamorphic

Keystone

 

ENTER

Position

 

Overscan Adjustment

0

PIP

 

PC & Component YPbPr Tuning

 

S-Video

EXIT Back

Keystone

2D Keystone

ENTER

EXIT Back

Keystone

1 0

EXIT Back

1. Press . 2. Press .

Using the projector

23

Page 23
Image 23
BenQ W5000 Adjusting the projected image, Adjusting the projection angle, Correcting picture distortion, No parallel sides