Installation
Electrical Connection
Wiring diagrams are located in the control compartment and on the back of the oven.
The electric motor, indicator lights and related switches are connected to the oven as follows:
1.Remove the bottom trim and control panel covers. Slide the control panel forward.
2.Connect the supply conduit to the wire duct lo- cated in the lower left hand corner on the back of the oven.
3.Run the supply wires through the duct to the front of the oven.
4.Connect the supply wires to the terminal block in the control compartment at the lower right corner of the oven.
5.Reinstall the bottom trim and control panel covers.
NOTE: To prevent damage there is no power to the heating elements when the blower is not operating.
THE BLODGETT OVEN COMPANY CANNOT AS- SUME RESPONSIBILITY FOR LOSS OR DAMAGE SUFFERED AS A RESULT OF IMPROPER INSTAL- LATION.
Terminal Block |
Figure 8
9