Any residual moisture inside the drum is due to the final testing which every washing machine
There is a packet of accessory partsundergoes before leaving the supplied with your washer. Check factory.
that all the accessory parts supplied
On the rear of the appliance:
for your model are there. If any parts are missing contact your dealer immediately.
Inside the drum:
Installation area
DANGER
Never ground the washer to plastic plumbing lines gas lines or hot water pipes.
Appliance stability is important otherwise the washing machine could walk during the spin cycles.
The installation area must be solid and even. Soft floor surfaces such as carpets or surfaces with foam backing are not suitable.
If the washing machine is to be installed on a weak wood floor consider the following:
-Water supply hose for cold water blue marking.
-Water supply hose for hot water red marking.
-Water drain hose.
-A bag which contains:
-Power cord with plug.
C = cold water connection H = hot water connection
Useful tools
The following tools are helpful:
-Box cutter.
-Flat head screwdriver.
-Closed wrench 1/2/13mm.
-Bubble level.
If possible place the washing machine in a corner of the room.
Screw a water resistant wooden board at least 3/4 thick to the floor.
Secure the feet of the washing machine with holding brackets. Order the holding brackets set from Bosch Customer Service WMZ 2200.
Pedestal Mounting
Dimensions
-Covers to be placed over the holes for the transport bolts after removing them.
-Clamp for drain hose.
-Elbow for attaching the drain hose e.g. to a sink.
-Wrench for levelling
Depending on the type of connection the following may also be required:
- Y?connector | can be | obtained | a | = | 27 in. 686 mm | |||
b = 30.7 in. 780 mm | ||||||||
from any hardware store in | ||||||||
c = 37.0 in. 940 mm | ||||||||
|
|
| ||||||
case there is only a cold water |
|
|
|
| ||||
connection | available. |
| d | = | 16 in. | 407 | mm | |
|
|
| Door | opening | angle | 180° | ||
If mounting the washer on the Bosch pedestal accessory no.WTZ1295 follow the instruc? tions supplied with the pedestal.
iInstall pedestal prior to removing transport bolts.
Closet
If installing the washer in a closet observe the minimum distances according to the following table:
Minimum | Installation Clearances | ||
|
|
| |
|
| ||
|
|
|
|
4 | |||
3 | |||
4 | |||
F | 4 | ||
|
|
|
|
Ventilation:
Approx. weight = 220 lbs 100 kgTop: 48 sq. in 310 sq. cm Bottom: 24 sq. in 155 sq. cm
8
