D9112B | Program Entry Guide | 3.0 User Interface EN | 47
Bosch Security Systems | 2/04 | 74-06145-000-D
Table 28: Authority Level Selections
Blank Disable this function for the authority level specified.
E Enable this function for the authority level specified. When the passcode is entered at the command
center, the panel checks the authority level. The panel executes the function only in areas where the
passcode has the authority to use the function.
When a passcode is entered into a command center that has either Account or Panel-Wide scope, the
user can use any panel-wide feature (such as Send a Report or Display Rev) as long as the user has
authority for the feature in at least one area where the command center has scope. If the function is area
specific the authority must be set for the specific function such as, Watch Mode.
Disarm
There are two disarming functions enabled by this prompt: Disarm All Areas and Disarm An Area. Blank and E
are not valid entries for this item.
Disarm All Areas: Disarms all areas according to the
Scope
of the command center where the function is
entered (see Cmd Cntr Assignment).
Disarm An Area: Disarms a single area. When this function is accessed the command center displays the armed
status of areas within its
Scope
.
How Command Center Scope affects area execution: An Area Command Center can execute this
function only in the area where the command center is assigned. An Account command center can
execute this function in all areas in the account where the user has authority. A Panel-Wide Command
Center can execute this function in all areas in the panel where the user has authority.
Default: P
Selection: P
P Passcode is always required for this function. When the passcode is entered at the command center,
the panel checks the authority level.
The panel disarms areas where the passcode is authorized within the
Scope
of the command
center. The command center display shows the disarmed areas.
Programming in O/C Options
Area O/C
and
Restricted O/C
determines whether
Opening
and
Closing
reports can be generated for a particular area.
L## Disarm
Default: See
Training Sheet
Selection: Blank or E
Blank Disable this function for Authority Level (L##) specified.
E Enable this function for Authority Level specified. When the passcode is entered at the command
center, the panel checks the authority level. The panel executes the function only in areas where the
passcode is authorized.
Programming in O/C Options
Area O/C
and
Restricted O/C
determines whether
Opening
and
Closing
reports can be generated for a particular area.
Whether
Opening
and
Closing
reports are generated by this user or not depends on the
L##
Area O/C
and
L## Restricted O/C
prompts in Authority Lvl Assign.